This one's a keeper, and I don't feel the need to look for another processor. The fact that the game can be started from any stage and all previously created creatures are available for selection at the creation screen means this should cause little disruption. The RP is absolutely terrific! I've been following Tony's path to this processor for a long time, and thrang's for a bit shorter time, and I've also tried my share of processors. I can understand why you mention it is an underrated processor. I just want to say thanks again to thrang for a terrific thread! You and Tony have found a real gem of a processor. I did not receive any measuring errors, based upon the lowered (10dB)volume, and the calibration produced much better results for my room.
If for some reason the volume level needs to be higher, a 'Measuring Error' will appear on the screen refer to figure 30. If the test signal was too loud, reduce it by using the Volume Control by 10dB (the example in figure 28 would now read -30.00dB). The size of your room, loudspeaker distance from the microphone position and the efficiency of the loudspeakers all effect the readings. If a lower volume is used all other sounds in the room should be minimized.Īt the top of page 26 in the MX-151 manual, there is a note: Note: The Desired maximum calibration volume (-4.0db) level and the current (now -20.00dB) volume indications in figure 28 will probably be different in your room. This may be uncomfortably loud to some and a lower volume may be used in some situations. This is from the McIntosh RP set up instructions: MEN220 and MX150 will initially indicate the correct volume setting up or down as needed to achieve 80Db at the microphone. Overall, the sound is much more solid with RP than with Audyssey on my previous processor. Now, I definitely like the sound better with RP turned on.
However, this time, after the initial sound check in the focus position, I turned the volume down 10db, and then continued with the focus and the room positions. On Saturday, I re-ran RP - again, achieving 97%. It was really loud! Things were rattling in the room. UPDATE: I ran RoomPerfect on Friday - achieved 97%.
0 kommentar(er)
